Grass Valley K2 Dyno Installation v.2.0 - Manual (Page 18)

Cable K2 Summit Production Client
1. If desired, mount the K2 Summit Client in an equipment rack. Refer to the K2 System Guide for
rack mount procedures.
2. Make cable connections. Connections for a typical system are illustrated.
C1 C2 C3 C4
!
OK
~AC
!
OK
~AC
SDI IN 1 SDI OUT 1 SDI OUT2 LTC I/O
AESAUDI O RS422
SDI OUT1 SDI OUT 2
USB/1394 100BT/1000BT
GPI
VGA REF. LOOP THROUG H
AESAUDI O RS422
LTC I/O SDI IN 2 SDI IN 3 SDI IN 1 SDI IN 2 SDI IN 3 SDI IN 1 SDI OUT 1 SDI OUT2 LTC I/O
AESAUDI O RS422
SDI OUT1 SDI OUT2
AESAUDI O RS422
LTC I/O SDI IN 2 SDI IN 3 SDI IN 1 SDI IN 2 SDI IN 3
Power
cord Power
cord
AES
audio
Keyboard
and mouse VGA
monitor
Channels (C1, C2, C3, C4) are bi-directional
Ethernet
control
connection
Optional:
Ethernet
media
(FTP)
connection
Use C1 as
record channel.
Connect SDI in Use C2 as
record channel.
Connect SDI in Use C3 as
play channel.
Connect SDI out Use C4 as
play channel.
Connect SDI out
Each channel can be both an input (record channel) and an output (play channel). For the typical
system, C1 and C2 are record channels and C3 and C4 are play channels.
The control connection between the K2 Summit Client and the K2 Dyno Controller can be via
direct connect cable or via an Ethernet switch. Control connections must be on the same network
(subnet).
For complete cabling instructions, refer to the K2 System Guide. If using ChannelFlex Suite features,
refer to the K2 AppCenter User Manual.
Cable K2 Solo Media Server
1. If desired, mount the K2 Solo Media Server in an equipment rack. Refer to the K2 Solo Media
Server Accessories Installation Instructions for rack mount procedures.
18 K2 Dyno Controller Installation Manual 14June 2011
Cabling systems