2 amx-3981 card installation, 3 installation of the optical interface (option), 4 rear panels and connectors – Grass Valley AMX-3981 2014 User Manual
Page 11: 1 images of rear panel connectors
GUIDE TO INSTALLATION AND OPERATION
AMX-3981 | 5
2.2 AMX-3981 Card Installation
Once a matching rear connector panel has been installed, install the AMX-3981 card as follows:
1. Open the front panel of the frame.
2. Slide the AMX-3981 card into the slot and push gently on the handle to seat the connectors.
When using a double-slot-width rear panel, the card should be inserted into the right-most of the two slots.
Inserting the card into the wrong slot will not damage the card, and will be flagged by the on-card status LED
flashing red to indicate that there is no connection to the rear panel.
3. Close the front panel of the frame.
2.3 Installation of the Optical Interface (option)
Refer to Annex 3 on page 103.
2.4 Rear Panels and Connectors
2.4.1 Images of Rear Panel Connectors
The four available rear panels are shown in the figure below, and their various inputs and outputs are described.