Grass Valley ADVC-700 - Manual (Page 17)

Chapter 2 - Basic Operations
17
DV2 DV1
LOCKED
S-Video
Input and output connectors for
S-Video signal. The connector
on the upper row is video input,
and the connector on the lower
row is video output.
TC
Time-code I/O connectors. The
connector on the upper row is
TC input, and one on the lower
row is TC output.
Remote
Remote control connector.
Earth terminal
Connect an earth wire to this terminal, if necessary.
COMPOSITE
Input and output connectors for composite
video signal. The connector on the upper
row is composite input, and the connector
on the lower row is composite output.
DIP SW
REF
Input connectors receiving sync
signal. The LED lights red when
sync signal input is detected. The
REF connector has through output.
If a cable is not connected to the
output connector, it has a 75
automatic termination.
DV1 (6-pin)
Use a DV cable to connect the ADVC700
to a DV device or a PC. (Bus power is not
supplied.)
DV2 (4-pin)
Use a DV cable to connect the ADVC700
to a DV device or a PC.
DC-IN 12V
Connect the provided AC
adapter here.
P18
NOTES
- This unit will not work as an OHCI Hub with Grass Valley DV products.
- To use this unit as a Hub with OHCI devices, the application also needs to support
two or more devices.