Grass Valley ADVC-300 - Manual (Page 20)

20
[SW2] DIP switches [SW2] DIP switches [SW2] DIP switches [SW2] DIP switches [SW2] DIP switches
Allows you to make video and audio settings.
All the switches have been set to OFF at the time of shipment.
No.1 Video Audio Adjust Mode setting
Allows you to enable the adjustment on image and sound quality.
Usually, set this to [OFF: Normal] (Refer to P. 22).
OFF: Normal ON: Adjust
No.2 Chroma Filter Setting
Allows you to select the Chroma filter.
OFF: 1.3 MHz ON: 2.0 MHz
No.3 Component Level setting
Allows you to select the component level from SMPTE and BETACAM.
OFF: SMPTE ON: BETACAM
No.4 Aspect Ratio Enable setting
Allows you to enable the aspect ratio setting (No.5 Aspect Ratio
Select). If set to [OFF: Disable], the aspect ratio of “4:3” is used for
D1 output.
OFF: Disable ON: Enable
No.5 Aspect Ratio Select setting
Allows you to select the aspect ratio for D1 output.
OFF: 4:3 LetterBox ON: 16:9
No.6 Reserved
Not used (Usually, set it to [OFF].)
No.7 Reserved
Not used (Usually, set it to [OFF].)
The following functions are
changeable under the PC mode.
The set values are saved in the
ADVC-300's memory.
• Locked Audio Mode
([SW1] DIP switch No. 3)
• Audio Mode
([SW1] DIP switch No. 4)
The following functions are not
changeable from the PC.
• NTSC Setup Level
([SW1] DIP switch No. 5)
• Video Format
([SW1] DIP switch No. 6)
• Chroma Filter
([SW2] DIP switch No. 2)
• Component Level
([SW2] DIP switch No. 3)
• Aspect Ratio Enable
([SW2] DIP switch No. 4)
• Aspect Ratio Select
([SW2] DIP switch No. 5)
• Video Sync Mode
([SW2] DIP switch No. 8)
Tip