Grass Valley ADVC-300 - Manual (Page 19)

19
No.7 Standby setting
Allows you to set whether to use the standby feature (which detects
the signal coming from devices connected to the DV terminal).
OFF: Disable ON: Enable
* Standby feature
This feature turns ON/OFF the ADVC-300 power automatically af-
ter detecting ON/OFF of the power of the device connected to the
DV terminal.
You can use the [POWER] switch to turn ON/OFF the ADVC-300
power as usual even when the standby feature is active.
No.8 Operation Mode setting
Allows you to select the control method of ADVC-300.
OFF: UNIT ON: PC
* UNIT mode
In this mode, the ADVC-300 operates standalone, thus all the op-
erations are made via the buttons and indicators on it. To set the
operation mode, use the DIP switch for it. You can set up the qual-
ity of image and sound on the ADVC-300. This mode is provided
for using the ADVC-300 as a simple DV converter.
* PC mode
In this mode, the ADVC-300 is controlled by a computer connected
to it via the IEEE 1394 interface. Image and sound quality is con-
trolled from the computer. The buttons on the ADVC-300 are not
operable in this mode.
NOTE
When you use the standby fea-
ture, use either of the DV termi-
nal on the front or the one on the
rear, not both, for connecting your
device.
* Depending on the specification
of your device’s (computer’s)
DV terminal standby function
or the OHCI card specification,
the standby mode may not
work.
Operation Mode
The PC mode and UNIT mode are
available for your selection.
When changing the mode, be
sure to turn OFF the ADVC-300
power before setting the DIP
switch.
Tip