Grass Valley ADVC-300 - Manual (Page 14)

14
Names and functions of components Names and functions of components Names and functions of components Names and functions of components Names and functions of components
Front Front Front Front Front
(1) [INPUT SELET] switch
This switch sets the input mode to either of DV or analog. The
switch toggles between the following two modes:
• Analog > DV > Analog
* If the [INPUT SELECT] switch is held down for about 3 seconds, color
bars are output. Pressing the switch once again returns you to the DV
input mode.
(2) [DIGITAL IN] LED
Lights while the ADCV-300 is receiving signals from the DV termi-
nal and converting them to analog signals.
(3) [ANALOG IN] LED
Lights while the ADVC-300 is receiving signals from the analog
terminal and converting them to DV signals.
(4) STATUS LED
Lights in red when the Macrovision signal or any anomaly has
been detected.
When the standby feature has been enabled, this LED lights in
green if the ADVC-300 enters the standby mode.
(5) AUDIO IN L/R
Terminal for analog audio input.
(6) VIDEO IN
Terminal for composite video input.
(7) S-VIDEO IN
Terminal for S-video input.
(8) DV IN/OUT
Terminal for DV connection (4-pin). Connect this terminal to a DV
device or computer.
(4) (1) (5) (6) (7) (8)
(3) (2)