Grass Valley ADVC-300 - Manual (Page 18)

18
Setting up ADVC-300 Setting up ADVC-300 Setting up ADVC-300 Setting up ADVC-300 Setting up ADVC-300
[SW1] DIP switches [SW1] DIP switches [SW1] DIP switches [SW1] DIP switches [SW1] DIP switches
Allow you to set various modes. No.5, No.6 may differ depending on
your point of perchase.
NOTE
Before changing the DIP switch
settings, be sure to turn the
power OFF.
No.1 PHY Speed setting
Allows you to set the PHY Speed. (Usually, set to S400.)
OFF: S400 ON: S200
No.2 Update Mode setting
Allows you to set Update Mode. (Usually, set it to Normal.)
OFF: Normal ON: Update
No.3 Locked Audio Mode setting
Allows you to select whether to use the Locked Audio mode or not.
(Refer to P. 49.)
OFF: Locked ON: Unlocked
No.4 Audio Mode setting
Allows you to select audio frequency.
OFF: 48kHz/16bit ON: 32kHz/12bit
No.5 NTSC Setup Level setting
Allows you to set the black (setup) level. This switch is effective
only in the NTSC format.
OFF: 0 IRE ON: 7.5 IRE (North America, South Korea)
No.6 Video Format setting
Allows you to select video signal format.
OFF: NTSC ON: PAL
When both of No.5 NTSC Setup Level and No.6 Video Format are set
to ON, the SECAM format is used.
* At this time, the SECAM format is used for input and PAL format for
output.