Grass Valley 8964DEC v.1.1.0 - Manual (Page 21)

8964DEC/-FS — Instruction Manual 21
Configuration
The line numbers for each category above are defined in Table 3 for both
525 and 625 line rates on the 8964DEC module.
Note The categories may not match the line definition as specified in the applicable
standard.
Line pairs in the P_Active line category can be reserved for carrying data
by configuring Data Line Pairs with local or remote controls. Refer to
Table 4 for a listing of the Data Line Pairs lines that are available with each
setting.
All Lines – Composite In Video Path Processing
The incoming video composite signal path for each channel can be pro-
cessed before decoding. These processing functions affect all lines of video
at once, both active picture lines and VBI lines.
The following processing functions are available for the video composite
input signals:
• AGC and ACC on or off – the Auto Gain Control (AGC) and Auto
Chroma Control (ACC) are set to default to the off condition (
Enable AGC
and ACC checkboxes not checked). This is the recommended state and
provides the following controls for video and chroma gain:
• Input Video Gain – adjust the input video gain in percent relative to
100% (100% = 1 V p-p). AGC operation is based on sync tip.
Table 3. Line Numbers for 8964DEC Line Categories
Line Categories
Label
525 625
Start End Start End
F_Active
25 (F1)
288 (F2)
263 (F1)
525 (F2) 29 (F1)
342 (F2)
310 (F1)
623 (F2)
P_Active
21 (F1)
284 (F2)
24 (F1)
287 (F2)
24 (F1)
337 (F2)
28 (F1)
341 (F2)
CVBI
10 (F1)
273 (F2)
20 (F1)
283 (F2)
6 (F1)
319 (F2)
23 (F1)
336 (F2)
FVBI
1 (F1)
264 (F2)
9 (F1)
272 (F2)
624 (F1)
311 (F2) 5 (F1)
318 (F2)
Table 4. Lines Reserved for Carrying Data
525 Line
Selection
Data Line Pairs
Reserved
625 Line
Selection
Data Line Pairs
Reserved
None None None None
21/284 21/284 24/337 24/337
22/285 21/284 – 22/285 25/338 24/337 – 25/338
23/286 21/284 – 23/286 26/339 24/337 – 26/339
24/287 21/284 – 24/287 27/340 24/337 – 27/340
28/341 24/337 – 28/341