Grass Valley 8949MDA-CXF - Manual (Page 26)

26 8949MDA-CXF/-SXF — Instruction Manual
Power Up
A red FAULT LED indicates an error situation and, when noted with the
other indicator LEDs, can indicate a specific problem area.
Table 4 describes
signal output and LED indications for the various input/reference combi-
nations.
Table 4. LED Indicators
LED Indication Condition
FAULT
(red)
Off Normal operation
On continuously Module has detected internal fault
COMM
(yellow)
Off No activity on frame communication bus
Long flash Location Command received by the module from a remote control system
Short flash Activity present on the frame communication bus
CONFIG
(yellow)
Off Module is in normal operating mode
On continuously Module is initializing, changing operating modes or updating firmware
PWR
(green)
Off No power to module or module’s DC/DC converter failed
On continuously Normal operation, module is powered
PRES OPT MOD
(yellow)
Off Fiber optic submodule not installed
On Fiber optic submodule installed
COMPOSITE SETUP
(green)
Off Setup disabled
On Setup enabled
FACTORY
(yellow)
Off Normal operation
On Test mode or factory mode
MONITORING MODE
(Channel 1
F0, F1, F2 and F3)
(yellow)
F0 F1 F2 F3
Off Off Off Off 0000 --> Auto
Off Off Off On 0001 --> 1080i/50
Off Off On Off 0010 --> 1080i/59.94
Off Off On On 0011 --> 720p/50
Off On Off Off 0100 --> 720p/59.94
Off On Off On 0101 --> 480i/59.94
Off On On Off 0110 --> 576i/50
Channel 1
PRES SIG EQ
(green)
Off No presence of signal on BNC J9 connector
On continuously Presence of signal on BNC on J9 connector
PRES SIG OPT 1
(yellow)
Off No presence of optical signal on Fiber optic input 1
On continuously Presence of optical signal on Fiber Optic input 1
PRES SIG OPT 2
(yellow)
Off No presence of optical signal on Fiber optic Input 2
On continuously Presence of optical signal on Fiber Optic Input 2