Grass Valley 8949MDA-CXF - Manual (Page 19)

8949MDA-CXF/-SXF — Instruction Manual 19
Installation
6. After removing the covers and cleaning the fiber optic connectors,
carefully attach the duplex ferrule end of the 2-channel fiber jumper
cable assembly to the submodule until the two connectors snap into
place (top of
Figure 10 ).
7. Guide the 2 fiber jumper cables around towards the front of the board
and slip them through the two white plastic cable guides to hold them
in place.
8. Find the ferrule end of the simplex (single) fiber jumper cable that
corresponds to the top duplex cable (labeled A for clarity in this
illustration) and after removing the protective cover and cleaning the
connector, connect it to the bottom of the rear fiber connector (labeled
A) as shown in
Figure 10 .
9. Find the ferrule end of the simplex (single) fiber jumper cable that
corresponds to the bottom duplex cable (labeled B) and after removing
the protective cover and cleaning the connector, connect it to the bottom
of the rear fiber connector (labeled B) as shown at the bottom of
Figure 10 .
10. This completes the installation of the submodule.
Figure 10. Installing Fiber Jumper Cables
Plastic cable guides
Rear Fiber
Connector
Simplex Connector
for Channel A
Simplex Connector
for Channel B
Fiber jumper cable assembly
8567_02
r0
Connect Channel A to top connector (not labeled).
Connect Channel B to bottom connector (not labeled).
A
A
B
B
Duplex connector end