Grass Valley 8949MDA-CXF - Manual (Page 20)

20 8949MDA-CXF/-SXF — Instruction Manual
Installation
Front Module Installation
After installing the rear module and the fiber optic submodule option if
purchased, if an 8900NET (Net Card) is not present in the frame, configure
the module with front edge onboard controls as described in
Configuration
Switches S1 and S2 on page 12 , before installing the front module. If you
have an 8900NET card, follow the configuration instruction in Configuration
on page 27 after installing the front module:
1. Remove the front cover of the frame if required.
2. Locate the front slot corresponding to the corresponding rear module.
3. Insert the front module so that the plastic card guides on the module
top and bottom edges go over the upper and lower raised rail guides on
the right of the top and bottom of the slot (
Figure 11 ).
4. Carefully slide the module into the rear connector, making sure the
fiber optic rear connector is properly aligned.
5. Lock the front module ejector tab into the locking pin.
Figure 11. Front Module Installation
8543_02
Slide top and bottom card carriers on module
over top and bottom guides on right of slot.
Module installed
Locking Pin
Card Carriers
Card Carriers
Front Module Side View