Grass Valley 8949MDA-CXF - Manual (Page 22)

22 8949MDA-CXF/-SXF — Instruction Manual
Cabling
Video Outputs
The 8949MDA-CXF or 8949MDA-SXF outputs conform to the video stan-
dards listed in the output specifications in
Table 5 on page 50 . Both
modules require the 8900WFR-XFR rear module.
The 8949MDA-CXF has four electrical outputs for distributing the original
SD-SDI or HD-SDI input signal. It also provides four downscaled outputs
for monitoring each output in PAL or NTSC format with controls for
enabling or disabling composite setup (NTSC only) and a composite color
bars test signal, and aspect ratio controls for downscaled HD video.
The 8949MDA-SXF has four electrical outputs that distribute the original
SD-SDI or HD-SDI input signal. It also provides four downscaled moni-
toring outputs in SD-SDI format with aspect ratio controls for downscaled
HD video
Electrical outputs are always enabled. Fiber optic outputs must be enabled
during configuration using the local onboard controls (
Configuration
Switches S1 and S2 on page 12 ), the Settings web page ( page 37 ), or the
Newton Control Panel.
Note Fiber optic outputs available depend on the presence and type of fiber optic
submodule installed as listed in
Table 2 on page 16 .
• Electrical output BNCs (always available and enabled)
• Fiber Output TX 1 and TX 2 (requires Dual Transmitter submodule), or
• Fiber Output TX 2 (requires Transceiver submodule).