Grass Valley 8949MDA-CFR v.1.0.X - Manual (Page 21)

8949MDA-CFR and 8949MDA-SFR Instruction Manual 21
Remote Configuration
Note Refresh button must be clicked to update the page after any changes.
8949MDA-CFR and 8949MDA-SFR Links and Web Pages
The 8900 GUI provides the following links and web pages for the 8949MDA-CFR
and 8949MDA-SFR modules (
Figure 10 below):
• Status – reports input and output signals and frame bus communication status
and module information (below),
• Settings – allows the configuration of the inputs and outputs ( page 23 ),
• Slot Config – provides the slot identification, the memory slot and the reports
for the frame health and the SNMP trap (
page 25 ).
The 8949MDA modules can use one type of the three fiber optic submodules:
1310NM-DRL (Dual Receiver), 1310NM-DTL (Dual Transmitter) or
1310NM-TRL (Transceiver). The fiber optic submodules are placed in the fiber
connector. A different web page is linked to each type.
Figure 10. 8949MDA Web Page Links
Status Web Page
The Status web page ( Figure 11 on page 22 for 8949MDA-CFR) shows the signal
status of the input signal(s) and communication with the frame bus. Color coding
of the display indicates the signal status. Refer to Web Browser Interface
on
page 19 for an explanation of the color coding.
Note On the 8949 modules, input signals are represented by up to three input
signal arrows. If the status of either input signal changes, it will be reflected
in the color status of the arrow and the Status LED on the module web pages.
To determine specific signal status for DA, refer to the Status web page or the
on-board LED.
Under the Status title are given the model, the description and the frame location.
Below, the graphic shows the input and output signals. If the status of either input
or output changes, it will be reflected in the color status of the arrow (linked to the
Input Reporting parameter) and the status LED on the module web page.
Information about the module, such as Part Number, Serial Number, Hardware
Revision, Firmware Revision 1 (CPLD), Firmware Revision 2 (FPGA), Software
Version, and Asset Tag number are given in a properties section at the bottom of
the Status Web Page.
Use
this
link