Grass Valley 8949MDA-CFR v.1.0.X - Manual (Page 12)

12 8949MDA-CFR and 8949MDA-SFR Instruction Manual
Installation
3. Insert the corresponding rear module in the slot.
4.
Replace both retainer strips on each side of the rear module and tighten the
screws to secure the rear module.
Figure 3. Back Panel
Note To extract the rear module, do not forget to extract the front module first.
Front Module Installation
Note Before installing the front module, the rear module must be already placed.
Please refer to the
Optional Fiber Optic Submodule below, if the fiber optic
submodule is present.
After installing the rear module:
1. Unscrew and remove the front cover.
2. Insert the front module in the guides of the corresponding slot.
3. The module ejector tab ( Figure 4 ) must be locked in its locking pin.
Figure 4. Module Ejector Tab Locking Pin
Optional Fiber Optic Submodule
When the fiber optic submodule is present, it is advised to take some precautions
so as not damage the modules.
8434-
03
8434 -04
Ejector
Tab
Locking Pin