Grass Valley 8949MDA-CFR v.1.0.X - Manual (Page 14)

14 8949MDA-CFR and 8949MDA-SFR Instruction Manual
Cabling
2. Unlock the module by flipping the handle to the left.
3.
Remove the fiber optic submodule by using its handle.
Cabling
Cabling to the 8949MDA-CFR or 8949MDA-SFR module is done on the BNCs
and the fiber connector on the rear module. Refer to
Figure 5 on page 13 for the
fiber optic cabling and Figure 6 on page 15 for a detailed illustration of the rear
connections referenced below. Cabling of the rear module depends on what fiber
optic submodule option is installed as below:
• 8949MDA-CFR/-SFR without fiber optic submodule option (electrical only),
• 8949MDA-CFR/-SFR with 1310NM-DRL (Dual Receiver Fiber Optic)
• 8949MDA-CFR/-SFR with 1310NM-DTL (Dual Transmitter Fiber Optic),
and
• 8949MDA-CFR/-SFR with 1310NM-TRL (Transceiver Fiber Optic).
The 8949MDA-CFR or 8949MDA-SFR will accept any of the video standards
listed in the input specifications in
Table 6 on page 27 .
Connect a video input to BNC J9 or Fiber.
The 8949MDA-CFR or 8949MDA-SFR outputs conform to the video standards
listed in the output specifications in
Table 6 on page 27 .
Table 3 below and Table 4 on page 15 gives the inputs and the possible video
output connections for the 8949MDA modules in Figure 5 on page 13 .
Table 3. Cabling Inputs and Outputs for 8949MDA-SFR Module
Fiber Optic Submodule Inputs in HD Outputs
Dual receiver J9
or Fiber 1
or Fiber 2 J1, J3, J5, J7: 4 HD-SDI outputs
J2, J4, J6, J8: 4 downscaled SD-SDI
outputs
Dual transmitter J9 J1, J3, J5, J7: 4 HD electrical outputs
Fiber 1 and Fiber 2: 2 optical HD outputs
J2, J4, J6, J8: 4 downscaled SD-SDI
outputs
Transceiver J9
or Fiber 1 J1, J3, J5, J7: 4 HD electrical outputs
Fiber 2: 1 optical HD outputs
J2, J4, J6, J8: 4 downscaled SD-SDI
outputs