Standard selections web page – Grass Valley 8937 v.1.1.0 User Manual
Page 30
30
8937/8937D — Instruction Manual
Configuration
Standard Selections Web Page
Use
this
link
The Standard Selections web page allows you to set loss of signal reporting
and the operating mode for the 8937 and 8937D modules. Refer to the spe-
cific 8937 or 8937D heading below.
8937 Module
for the Standard Selections web page for the 8937.
Select the
Apply
button after making each selection.
Set the following parameters on this web page:
•
Set the Report Loss of Sig 1 input presence reporting to
Yes
or
No
. Dis-
abling this control will gray out the Input Signal(s) arrow on the Status
web page graphic shown in
•
The Input Signal 1 field will report the status of the input signal as one
of the following:
•
Signal Present,
•
Signal Not Present
, or
•
Not Monitored
(
Report Loss of Sig 1
set to
No
)
•
When the Mode 1 control is set to
Auto
, the
input bit rate standard is
detected by module and displayed in the
Current Bit Rate1
field.
•
When
Bypass
is set for Mode 1,
Bypass
will be displayed in the
Current Bit
Rate1
field.
Figure 16. 8937 Standards Selections Web Page