Deployment procedure summary, Maintenance task summary – H3C Technologies H3C Intelligent Management Center User Manual
Page 96
87
Deployment procedure summary
Step Remarks
References
1.
Enable SPB globally
on SPB devices from
their CLI.
To import a device to VFM's SPB module, you must
perform this step for a device to be identified as an
SPB device.
See the CLI SPB
configuration guide.
2.
Import SPB devices
to VFM's SPB
module.
After importing SPB devices, you can synchronize
their SPBM configuration to VFM's SPB module
instead of configuring SPB from scratch.
•
•
3.
Configure MST
region parameters.
MST region parameters include:
•
MST region name
•
MSTP revision level
•
MSTI 4092 to B-VLAN mapping
VFM activates the MST region parameters
automatically when it deploys MST settings to SPB
devices.
•
Configuring MST region
parameters for one
•
4.
Enable SPBM on
interfaces.
You must enable SPBM on the provider network
ports on all SPB devices.
5.
Configure and
deploy the B-VLAN
plan.
The B-VLAN plan contains B-VLAN to ECT
algorithm mappings.
To ensure correct SPT calculation for B-VLANs, the
B-VLAN to ECT algorithm mappings must be the
same across the SPB network.
To forward traffic to each other in a B-VLAN, two
SPB devices must map a B-VLAN to the same ECT
algorithm index.
6.
Create and deploy
SPB services to BEBs
based on the
B-VLAN plan.
In this step, you must set BEBs and configure the
following customer-side settings for the BEBs:
•
Assign I-SIDs to SPB services (also called "SPB
VSIs).
•
Set the multicast replication mode.
•
Configure Ethernet service instances on
attachment circuits to match customer traffic.
•
Assign a B-VLAN to each SPB service based on
the B-VLAN plan.
•
•
NOTE:
For BEBs, VFM automatically enables L2VPN and assigns names to SPB VSI.
Maintenance task summary
To maintain SPB devices, perform the following tasks:
•
•
•