7 managing networks, Overview, Network management privileges – H3C Technologies H3C Intelligent Management Center User Manual
Page 44: Predefined network management privileges

36
7 Managing networks
Overview
VCM provides a network module to manage logical networks rather than physical networks. A logical
network includes the following resources:
•
VLAN—VLANs are used to isolate networks, each VLAN representing a network. When a network
is selected to create a connection, the VM in the connection will be assigned to the VLAN of the
network. The VLAN information will be delivered to the edge switch to permit the VLAN traffic
through the interface that is connected to the VM. In an EVB network, VLANs can be used to
identify VSI traffic for filtering.
•
Max. Connections—Maximum number of connections supported by a single network. The value
can be determined based on the number of VMs and number of NICs on each VM. For example,
if 100 VMs reside in a network, it might be insufficient to set the maximum number of connections
to 100. This is because a VM can have multiple NICs with each NIC corresponding to one
connection, and the total connections might exceed the total number of VMs.
•
VSI Type—The VSI Type configured for a network assigns network configuration to VMs.
Network management privileges
Network management privileges of an operator determine the following information:
•
Network operations that can be performed by the operator.
•
Scope of networks the operator can manage.
Predefined network management privileges
An operator group uses one of the following privileges: ADMIN, Maintainer, and Viewer. Network
operations supported in VCM vary by the privilege, as shown
. Operators gain privileges to
perform network operations based on operator groups.
Table 4 Support for network operations by different privileges
Network operations ADMIN
Maintainer
Viewer
Accessing the network management page Supported Not
supported Not
supported
Adding, modifying, and deleting networks Supported Not
supported Not
supported
Adding, modifying, and deleting
connections for a network
Supported Supported Not
supported
Deploying vApps on a network
Supported
Supported
Not supported
Viewing connections on a network
Supported Supported Supported