beautypg.com

Gre tunnel backup at the headquarters – H3C Technologies H3C SecPath F1000-E User Manual

Page 20

background image

4

GRE tunnel backup at the headquarters

Figure 14 GRE tunnel backup at the headquarters


As shown in

Figure 14

, for higher network reliability, you can deploy multiple gateways at the

headquarters and specify one or more backup interfaces for the main tunnel interface on the main

gateway, such as Tunnel 1, to implement headquarters node backup and GRE tunnel backup. If the link

between the main gateway and the branch gateway goes down, the main tunnel interface will soon lose

the matching tunnel entry for forwarding packets to the branch. In this case, the main tunnel interface will

forward the packets to the backup interface, which will then forward the packets to the branch. You need
to configure the GRE over IPv4 mode on the backup interface.
When a matching tunnel entry on the main gateway exists, a backup interface can also participate in

tunnel selection that is based on tunnel priority. If you do not specify a GRE key on a backup interface,

the backup interface will have a lower priority than any P2MP tunnel entry. If you specify a GRE key on

the backup interface, the key value will be compared with the GRE key values in the P2MP tunnel entries,

and the smaller the key value, the higher the priority.

Advantages and Restrictions of the P2MP GRE Tunnel

Technology

The P2MP GRE tunnel technology features the following advantages:

Simple configuration. On the headquarters node, you only need to configure the P2MP GRE tunnel
mode, instead of configuring a P2P GRE tunnel with each branch node.

Low maintenance cost. When a branch is added, no manual configuration is required on the
headquarters node; the headquarters node will learn the address of the added branch and then

establish a tunnel with the branch node.

Flexible access of branches. As the headquarters node learns tunnel destination addresses
dynamically, whether the branches obtain public addresses dynamically or not does not impact the

configurations on the headquarters node. This allows for more flexible accesses for branches.

Wonderful interoperability and investment protection. Based on the standard GRE protocol, the
P2MP GRE tunnel technology requires no special or proprietary protocol, nor special requirements

on branch gateways. The branch gateways can be from any vendors as long as they support GRE.