H3C Technologies H3C WA3600 Series Access Points - Manual (Page 8)

3
Preparing for installation
Safety recommendations
WARNING!
Only qualified personnel can install and remove a WA3600 series and its accessories. You must read all
safety instructions supplied with the access points before installation and operation.
To avoid possible bodily injury and equipment damage, read the following safety recommendations
before you install a WA3600 series. Note that the recommendations do not cover every possible
hazardous condition.
• Take adequate safety measures to avoid injury and access point damage.
• Make sure that the ground is dry and flat and anti-slip measures are in place.
• Keep the chassis clean and dust-free.
• Do not place the access point in a moist area and avoid liquid surrounding the access point.
• Keep the chassis and installation tools away from walkways.
Examining the installation site
Before installation, examine the installation site to keep the AP under a good operational environment.
You can examine the installation site from the following aspects:
Temperature and humidity requirements
Table 3 Environment specifications
Specification Range
Operating temperature (indoor) –10°C to +55°C (14°F to 131°F)
Storage temperature –40°C to +70°C (–40°F to +158°F)
Operating humidity (noncondensing) 5% to 95%