H3C Technologies H3C WA3600 Series Access Points - Manual (Page 16)

11
Figure 10 T-rail holder
(1) T-rail clip (2) M4 × 8 screw nut (3) Clip holder
(4) T-rail holder (5) M3 × 6 screw nut (6) M4 × 8 screw
(7) M3 × 6 screw (8) Mounting hook
To mount the AP to a ceiling T-rail:
1. Loosen the two M3 × 6 screws on each clip holder just enough (do not remove the screws or they
may get lost).
2. Adjust the T-rail clips to make the T-rail holder wider than the T-rail. See callout 1 in Figure 11 . Then
lock the T-rail with the T-rail holder according to the arrow indicated in callout 2 in Figure 11 .
Figure 11 Fix the T-rail holder to the T-rail
3. Tighten the four M3 × 6 screws on the two clip holders until the screw heads touch the T-rail, and
then fix the screws.
4. Check whether the T-rail holder is fixed to the T-rail.
5. Hook the mounting clip (see callout 5 in Figure 12 ) of the wall-mounting bracket to the mounting
hook (see callout 4 in Figure 12 ) of the T-rail holder.
6. Insert the two M4 × 8 screws (see callout 1 in Figure 12 ) through the two 5 mm (0.20 in) diameter
holes on the wall-mounting bracket according to the dashed line shown in Figure 12 and fix the
screws to the T-rail holder.
7. Check whether the wall-mounting bracket is fixed to the T-rail.
8. Connect the AP to the network by using an Ethernet cable.