H3C Technologies H3C WA3600 Series Access Points - Manual (Page 10)

5
Installing the AP
CAUTION:
The WA3600 series is usually installed on a high position, such as a wall or ceiling, so the maintenance
personnel cannot log in from the console port to maintain and debug the AP. H3C recommends that you
log in to the AP through the console port to perform remote login (Telnet or web login) configuration, or
log in through Telnet or web by using the default login information before you install the AP. For more
information about logging in to the AP, see “ Logging in to the fat AP .”
Figure 3 Installation flowchart
Check before installation
Before you install an AP, check the following:
• Connect the power cord and connect the AP to the network. Check the LED status to make sure that
the AP can operate properly. For more information about AP LEDs, see “
Appendix LEDs and ports .”
• Check that cabling has been completed.
• The WA3600 series supports 802.3af-compliant PoE. To achieve the best performance, H3C
recommends that you adopt GE connection to the power device.
Wall mounting (II)
Start
Determine the installation position
Wall mounting (I)
Connect the AP to the
network
End
Check before
installation
Install the wall-
mounting bracket
T-rail mounting
Install the wall-
mounting bracket
Attach the T-rail
holder to the T-rail
Install the AP
Connect the
power supply
Secure the AP