H3C Technologies H3C WA3600 Series Access Points - Manual (Page 21)

16
Check after power-on
After powering on the AP, check the AP status LED. For more information about AP LEDs, see “ Appendix
LEDs and ports .”
Connecting the AP to the network
APs can access the Internet or metropolitan area network (MAN) through the Ethernet uplink interface. To
implement Internet or MAN access, connect the Ethernet port of the AP to an Ethernet port of an Ethernet
switch.
Checking the network connection for the fit AP
When the AP operates as a fit AP, all of its settings are configured on the AC. You can use the display
wlan ap all command to check the AP status on the AC. When the AP status is R/M, the AP has been
successfully connected to the AC (on a WA3628i-AGN for example).
display wlan ap all
Total Number of APs configured : 1
Total Number of configured APs connected : 1
Total Number of auto APs connected : 0
AP Profiles
State : I = Idle, J = Join, JA = JoinAck, IL = ImageLoad
C = Config, R = Run, KU = KeyUpdate, KC = KeyCfm
--------------------------------------------------------------------------------
AP Name State Model Serial-ID
--------------------------------------------------------------------------------
ap1 R/M WA3628i-AGN 210235A0T6B117000435
-------------------------------------------------------------------------------
Checking the network connection for the fat AP
When the AP operates as a fat AP, use the ping command to ping the uplink network. If the network can
be pinged successfully, the AP is successfully connected to the network.