H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 55)

47
Figure 19 Network diagram
Configuration procedure
1. Create VLANs, and assign corresponding ports to the VLANs, and configure the IP address of
each VLAN interface as shown in Figure 19 . (Details not shown.)
2. Configure AC 1:
# Configure a static route to 30.1.1.0/24, with the address of the next hop as 10.1.1.2 and the
default priority 60. This static route is associated with track entry 1.
system-view
[AC1] ip route-static 30.1.1.0 24 10.1.1.2 track 1
# Configure a static route to 30.1.1.0/24, with the address of the next hop as 10.3.1.3 and the
priority 80.
[AC1] ip route-static 30.1.1.0 24 10.3.1.3 preference 80
# Configure a static route to 10.2.1.4, with the address of the next hop as 10.1.1.2.
[AC1] ip route-static 10.2.1.4 24 10.1.1.2
# Create an NQA test group with the administrator admin and the operation tag test.
[AC1] nqa entry admin test
# Configure the test type as ICMP-echo.
[AC1-nqa-admin-test] type icmp-echo
# Configure the destination address of the test as 10.2.1.4 and the next hop address as 10.1.1.2
to check the connectivity of the path from AC 1 to AC 2, and then to AC 4 through NQA.
[AC1-nqa-admin-test-icmp-echo] destination ip 10.2.1.4
[AC1-nqa-admin-test-icmp-echo] next-hop 10.1.1.2
# Configure the test frequency as 100 ms.
[AC1-nqa-admin-test-icmp-echo] frequency 100
# Configure reaction entry 1, specifying that five consecutive probe failures trigger the track
module.
[AC1-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail threshold-type
consecutive 5 action-type trigger-only
[AC1-nqa-admin-test-icmp-echo] quit
# Start the NQA test.
Vlan-int5
10.2.1.2/24 Vlan-int2
10.1.1.2/24
Vlan-int2
10.1.1.1/24
AC 2
AC 1
AC 3
Vlan-int3
10.3.1.1/24
Vlan-int3
10.3.1.3/24
Vlan-int4
10.4.1.3/24
AC 4
Vlan-int5
10.2.1.4/24
Vlan-int4
10.4.1.4/24
30.1.1.0/24 20.1.1.0/24
Vlan-int6
20.1.1.1/24
Vlan-int7
30.1.1.1/24