H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 33)

25
Figure 11 Network diagram
Configuration procedure
1. Perform basic configurations according to the topology requirements. (Details not shown.)
2. Configure AC 1:
# Configure VLAN 2 and VLAN 3.
system-view
[AC1] vlan 2
[AC1-vlan2] quit
[AC1] vlan 3
[AC1-vlan3] quit
[AC1] interface WLAN-ESS 1
[AC1-WLAN-ESS1] port link-type hybrid
[AC1-WLAN-ESS1] undo port hybrid vlan 1
[AC1-WLAN-ESS1] port hybrid vlan 2 untagged
[AC1-WLAN-ESS1] port hybrid pvid vlan 2
[AC1-WLAN-ESS1] quit
[AC1] interface vlan-interface 2
[AC1-Vlan-interface2] ip address 202.38.160.1 255.255.255.0
# Create a VRRP group 1 on VLAN-interface 2 and set its virtual IP address to 202.38.160.111.
[AC1-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Assign AC 1 higher priority than AC 2 in VRRP group 1, so that AC 1 can become the master.
[AC1-Vlan-interface2] vrrp vrid 1 priority 110
# Configure the authentication mode of the VRRP group as simple and authentication key as hello.
[AC1-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello
# Set the interval for Master to send VRRP advertisement to four seconds.
[AC1-Vlan-interface2] vrrp vrid 1 timer advertise 4
# Configure AC 1 to operate in preemptive mode, so that it can become the master whenever it
works normally, and configure the preemption delay as five seconds to avoid frequent status
switchover.
[AC1-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5