H3C Technologies H3C S5120 Series Switches User Manual
Page 32

24
•
Install the interface cards in proper slots as needed. Each S5120-EI series provides two expansion
slots.
•
Determine the ports on different devices to be connected.
When 2-port interface cards are used to constitute an IRF fabric and the ports are not assigned to any
aggregation group, ports of the interface card in slot 1 (MOD 1) can be connected to ports of MOD 1
or MOD 2. However, the left port can be connected to only the right port of another interface card, that
is, two ports at the same side cannot be connected, as shown in
Figure 27 Cable connections of an IRF fabric in the non-aggregate mode with 2-port interface cards
•
When 2-port interface cards are adopted in an IRF fabric with ports operating in the aggregation
mode, ports of MOD 1 can only be connected to ports of MOD 2, and the locations of the ports of
the interface cards are not limited.
Figure 28 Cable connections in an IRF fabric in the aggregation mode with 2-port interface cards
•
1-port interface cards do not support port aggregation in the IRF fabric. When 1-port interface
cards are connected for an IRF fabric, the port of MOD 1 can only be connected to the port on
MOD 2, as shown by callout 1 in
; when a 1-port interface card is connected to a 2-port
interface card for an IRF fabric, the port of MOD 1 can only be connected to the right port of the
2-port interface card, as shown by callout 2 in