H3C Technologies H3C S5120 Series Switches User Manual
Page 18
10
(1) Front square-holed post
(2) Load-bearing screw
(3) Rear panel
(4) Rear square-holed post
(5) Rear mounting bracket
(6) Screw used to attach rear mounting brackets to rear posts
(7) Front mounting bracket
After the switch is pushed into the rack, make sure the upper edge of rear mounting brackets makes
close contact with the load-bearing screw, as shown in
.
Figure 9 Front and rear mounting bracket installation (1)
(1) Rear panel
(2) Rear square-holed post
(3) Load-bearing screw
(4) Rear mounting bracket
7.
Have another person to attach the other end of the front mounting brackets to the front brackets
with M6 screws and cage nuts and make sure front and rear mounting brackets have attached the
switch in the rack securely, as shown in
.