H3C Technologies H3C S5130 Series Switches - Manual (Page 55)

48
Switch model
Port mode
LED (Mode)
status
Status Description
• S5130-52S-PWR-EI
• S5130-52TP-PWR-EI
Steady
green (rate
mode)
Steady green
The port is operating at 1000 Mbps, and a link is
present on the port.
Flashing green
The port is sending or receiving data at 1000
Mbps.
Steady yellow
The port is operating at 10/100 Mbps, and a link
is present on the port.
Flashing yellow
(not 3 Hz) The port is sending or receiving data at 10/100
Mbps.
Flashing yellow
(3 Hz)
POST has failed on the port.
Off No link is present on the port.
Flashing
green (PoE
mode)
Steady green The port is supplying PoE correctly.
Flashing green
(3 Hz)
• The PD power requirement exceeds the port
PoE capacity.
• The port fails to meet the power requirement of
the PD because of power insufficiency of the
switch.
Steady yellow
A non-PD device is attached to the port, or the port
is experiencing a PoE failure.
Flashing yellow
(3 Hz)
POST has failed on the port.
Off The port is not supplying PoE.
The S5130-28S-EI, S5130-28TP-EI, S5130-28S-PWR-EI, S5130-28TP-PWR-EI, and S5130-28S-HPWR-EI
switches provide two single-color LEDs for each 10/100/1000Base-T autosensing Ethernet port to
indicate their operating status. When one of the two LEDs is on, the other is off.
Table 22 10/100/1000Base-T autosensing Ethernet port LED description for S5130-28S-EI,
S5130-28S-PWR-EI, and S5130-28S-HPWR-EI switches
Switch model
Port mode
LED (Mode)
status
LED Status Description
• S5130-28S-EI
• S5130-28TP-EI
N/A
Green LED
Steady on
The port is operating at 1000
Mbps, and a link is present on
the port.
Flashing
The port is sending or receiving
data at 1000 Mbps.
Off
No link is present on the port, or
the port is not operating at 1000
Mbps.
Yellow LED Steady on
The port is operating at 10/100
Mbps, and a link is present on
the port.