H3C Technologies H3C S5130 Series Switches - Manual (Page 52)

45
SFP+ port
The switch provides SFP+ ports. You can install the 1000 Mbps SFP transceiver modules in Table 15 , the
SFP+ transceiver modules in Table 16 , and the SFP+ DAC cables in Table 17 in the SFP+ ports as
needed.
Table 16 SFP+ transceiver modules available for the SFP+ ports
SFP+ transceiver
module
Central
wavelength
Connector Fiber
Max transmission
distance
SFP-XG-SX-MM850-A 850 nm LC
50/125 μm multi-mode
optical fiber
300 m (984.3 ft)
62.5/125 μm
multi-mode optical fiber
33 m (108.27 ft)
SFP-XG-LX-SM1310 1310 nm LC
9/125 μm single-mode
optical fiber
10 km (6.21 miles)
Table 17 SFP+ DAC cables available for the SFP+ ports
SFP+ DAC cable Max transmission distance
LSWM1STK 0.65 m (2.13 ft)
LSWM2STK 1.2 m (3.94 ft)
LSWM3STK 3 m (9.84 ft)
LSTM1STK 5 m (16.40 ft)
NOTE:
H3C recommends that you use H3C 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, or
SFP+ DAC cables for the SFP+ ports on the switch. The H3C 1000 Mbps SFP and SFP+ transceiver
modules are subject to change over time. For the most up-to-date list of SFP and SFP+ transceiver modules,
contact your H3C sales representative or technical support engineer.
For more information about the 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, and
SFP+ DAC cables, see H3C Low End Series Ethernet Switches Pluggable Modules Manual.
Figure 53 SFP+ DAC cable
(1) Connector (2) Pull latch