H3C Technologies H3C S12500 Series Switches - Manual (Page 71)

62
Step Command Remarks
14. Apply the QoS policy.
• Applying the QoS policy to an interface
• Applying the QoS policy to a VLAN
• Applying the QoS policy globally
Choose one
application
destination as
needed.
15. Display the priority marking
configuration.
display traffic behavior user-defined
[ behavior-name ] [ | { begin | exclude | include }
regular-expression ]
Optional.
Available in any
view.
Priority marking configuration example
Network requirements
As shown in Figure 17 , the enterprise network of a company interconnects hosts with servers through
Device. The network is described as follows:
• Host A and Host B are connected to GigabitEthernet 3/0/1 of Device.
• The data server, mail server, and file server are connected to GigabitEthernet 3/0/1 of Device.
Configure priority marking on Device to meet the following requirements:
Traffic source Destination Processing priority
Host A, B Data server High
Host A, B Mail server Medium
Host A, B File server Low
Figure 17 Network diagram
Configuration procedure
# Create advanced ACL 3000, and configure a rule to match packets with destination IP address
192.168.0.1.
system-view