Ensemble Designs BrightEye 75 HD/SD Analog to Digital Video Converter and Analog Audio Embedder - Manual (Page 5)

TM
BrightEye 75
BrightEye 75 - Page 5
REAR CONNECTORS
All connections to the BrightEye 75 converter are made on the rear of the unit.
Refer to the illustration below.
Power Connection
Connect a modular power supply to the 12 volt DC power input connection on the
far left of the unit. Use the locking ring to secure it.
USB Connector
The USB connector is used to provide more comprehensive control, diagnostics,
and upgrades to the unit from a PC or Mac. Use the BrightEye Control applica-
tion included on CD-ROM to make adjustments as described in the
OPERATION
section of this user guide.
Audio In
This 6-pin Phoenix connector provides two channels of analog audio input. Wiring
is done by inserting the connector provided with the unit. The pinouts are shown
in the diagram below.
To connect audio to this connector, strip the audio wire to about 3/8” (8 mm).
Solder tinning is not required. Push the wire into the opening at the bottom of
the connector to seat the connection. This will snap the wire into place. To remove
the wire, push in the pin above the connection with a small pointed tool. This will
release the wire from the connector.
Balanced Analog Audio Connection – to connect the audio input to an audio
XLR connector, connect the pins as follows:
• Attach Ground from Pin 1 of the Audio In to Pin 1 of the XLR.
• Attach the + (plus) signal from Pin 3 of the Audio In to Pin 2 of the XLR.
• Attach the – (minus) signal from Pin 2 of the Audio In to Pin 3 of the XLR.
BrightEye 75 Rear Connectors
Ch 1 Ch 2
Push in to release Pin 1
+ G - G + -