Ensemble Designs BrightEye 75 HD/SD Analog to Digital Video Converter and Analog Audio Embedder - Manual (Page 14)

BrightEye 75 HD/SD Analog to Digital Converter and Analog Audio Embedder
BrightEye 75 - Page 14
Config Menu
Use the
Config menu to set the following output conditions for the output signal:
• Signal Mute – select the condition for muting the output signal to
No Muting, Mute On Noise, or Freeze on Noise.
• Analog Setup – set to On if setup is present on the analog input, or Off if
no setup is present.
• V Blanking – set the vertical blanking to Narrow (NTSC: lines 1-9,
PAL: lines 1-6) or Wide (NTSC: lines 1-20, PAL: lines 1-22).
• Comb Mode – set the comb filtering to Comb On or Comb Off.
• Peak Indicator – selects the amount of headroom used in determining
peak indication. Chose Clipping, 2 dB Headroom, 4 dB Headroom,
6 dB Headroom, 8 dB Headroom, or 10 dB Headroom.
• Dig Ref Level – selects the digital reference output level. Choose -20 dBFS or
-18 dBFS.
• Anlg Ref Level – selects the analog audio input level for embedding.
Choose - 10 dBu or +4 dBu.