Ensemble Designs BrightEye 75 HD/SD Analog to Digital Video Converter and Analog Audio Embedder - Manual (Page 12)

BrightEye 75 HD/SD Analog to Digital Converter and Analog Audio Embedder
BrightEye 75 - Page 12
Mixer Menu
Use the Mixer Menu to adjust the parameters of the embedded audio input signal.
• Output 1 – provides peak/VU status for output channel 1. The Peak/VU
indicator illuminates red when the audio level exceeds the headroom level
set with the
Peak Indicator control in the Config menu. Additionally, the
indicator illuminates yellow when the output level exceeds 0 VU, or illumi-
nates green when the output is above -20 VU. When the output level is
below -20 VU, the indicator does not illuminate.
• Output 2 – provides peak/VU status output channel 2. The Peak/VU
indicator illuminates red when the audio level exceeds the headroom level
set with the
Peak Indicator control in the Config menu. Additionally, the
indicator illuminates yellow when the output level exceeds 0 VU, or illumi-
nates green when the output is above -20 VU. When the output level is
below -20 VU, the indicator does not illuminate.
• Input Ch 1 – assign Input Channel 1 to the desired output bus or tie it to
Channel 2. Set the input level using the slider or by entering a number in
the
dB field and pressing the Enter key on your PC.
• Input Ch 2 – assign Input Channel 2 to the desired output bus or tie it to
Channel 1. Set the input level using the slider or by entering a number in
the
dB field and pressing the Enter key on your PC.
Clicking Tie on either channel ties the two slider controls together so that their
output levels can be adjusted in tandem.
Click the Default button to return to the default value.
Click the Invert button to invert the phase of the audio content.