Ensemble Designs BrightEye 75 HD/SD Analog to Digital Video Converter and Analog Audio Embedder - Manual (Page 17)

TM
BrightEye 75
BrightEye 75 - Page 17
SPECIFICATIONS
Analog Video Input
Number
One
Signal Type HD or SD: Y, Pr, Pb (SMPTE or Beta levels)
HD or SD: Analog Component RGB (sync on green)
Analog Composite PAL or NTSC
Analog S-Video PAL or NTSC
Resolution Digitized at 12 bits
Impedance 75 1
Return Loss > 40 dB
Input DC +/- 1 volt DC
Input Hum < 100 mV
Analog Audio Inputs
Number Two
Type Balanced
Impedance > 15K 1
Max Input Level 24 dBu
CMRR > 60 dB, 20 Hz to 10 KHz
Quantization 24 bits, 128x oversampled
Sample Rate 48 KHz
Reference Level -10 dBu or + 4 dBu
Frequency Response ± 0.1 dB, 20 Hz to 20 KHz
Crosstalk < 106 dB
Dynamic Range > 106 dB
Serial Digital Output
Number One
Type Follows input standard
HD Serial Digital 1.485 Gb/s
SMPTE 274M, 292M or 296M or
SD Serial Digital
270Mb/s SMPTE 259M-C
Impedance 75 1
Return Loss > 15 dB
Max Cable Length 100 meters for HD
300 meters for SD
(Belden 1694A)
Analog Video to SDI Performance
Bit Resolution 14-bit input quantization, 4x oversampling
Decoding Fully adaptive comb filter
K Factors > 1%
Signal to Noise > 64 dB weighted
Freq Response ± 0.1 dB, 0 to 5.5 MHz in SD
± 0.1 dB, 0 to 12 MHz; ± 0.5 dB, 12 to 30 MHz in HD