Ensemble Designs 9455 3G Clean and Quiet Protection Switch - Manual (Page 48)

www.ensembledesigns.com 7435 and 9455 - page 48
Model 7435 and 9455 Clean and Quiet Protection Switches
Updating Software: Step 3
Set the subnet mask for the 9455/7435 module. Use the Subnet menu in Avenue PC or on your Touch
Screen. The Subnet menu is detailed below an illustrated on the following page.
Subnet Menu
The Subnet menu shown on the following page allows you to change the subnet mask of your
94555/7435 module. In order to use the Ethernet port to update module software, the subnet mask
must be set in accordance with the size and topology of your network. The default setting as received
from the factory is for a smaller network: 255.255.255.0. For a larger network, a typical setting is
255.255.0.0. If in doubt, use the setting for a larger network.
These are general instructions. We recommend that you consult your IT staff if you are uncertain about
any of these network configuration settings.
To Set the Subnet Mask
1. From the Subnet menu, modify the settings as needed. Use the arrow buttons to change the
settings, or touch each number field to use the keypad.
2. When finished, press Save. Both the Cancel and Save buttons turn black to indicate that your new
settings have been saved.
Note that when using Avenue PC instead of the Touch Screen interface, after entering numbers into
the number fields, you will need to hit the “enter” or “return” key for the change to register.