Freeze menu – Ensemble Designs 7160 Serial Digital Protection DA User Manual
Page 22
www.ensembledesigns.com
7160-22
Model 7160 HD/SD/ASI/310 Protection DA
Freeze Menu
The Freeze menu shown below allows you to configure the following parameters for a video freeze
condition:
Freeze Mode
•
– set the freeze detection to Clean Source, Noisy Source, or Off.
Freeze Time
•
– set the amount of time that can elapse in seconds before the protect switch
switches to the Secondary input after a video freeze condition is detected.
The following status indicators can be monitored by Avenue PC alarm functions.
Pri Frz Status
•
– indicates the freeze status of the Primary as Frozen or Un-Frozen.
Note: If either Noisy Source or Clean Source are selected, and Freeze test is set to Off in the
Configuration menu, use of Avenue PC alarms is allowed without activating a switch to the
Secondary Source. Primary Freeze Error Counts are then active.