ARAG Digiwolf Tank filling system - Manual (Page 8)

8
3.4 Monitor rotation
In case of vertical assembly, to simplify
the use of the DigiWolf it is possible to
rotate the monitor by 90° with respect to
the body.
1) Remove the fork from the monitor using a screwdriver.
2) Remove the monitor from the flowmeter body.
If the monitor is turned upside down, the letters A and
B can be seen: these correspond to the two possible
monitor positions (parallel and perpendicular to the
body).
DigiWolf is supplied with the sensor in position A (paral-
lel to the body).
With the aid of a screwdriver, loosen the screw locking
the sensor
without removing it.
Rotate the sensor anti-clockwise until reaching B stop
position.
Tighten back the screw without forcing it. The monitor
is ready to be fitted in perpendicular position to the body.
Fit the monitor back on the flowmeter body.
INSTALLATION