ARAG Digiwolf Tank filling system - Manual (Page 20)

20
1
2
APP ROX IMA TE CO NST ANT XXX
8) Refit the sensor housing block on the flowmeter body tightening the ring nut in a clockwise
direction until it stops
paying attention to keep the arrow on the coupling facing the flow
direction.
10.3 OR replacement
With the removed sensor housing block (see Par. 10.2) proceed as follows:
1) Remove the fork from the ring nut using a screwdriver.
2) Remove the ring nut.
- OR replacement:
Replace the ORs ( Code G10051V - ARAG spare parts catalogue).
3) Refit the sensor housing block ensuring that the fork is correctly
inserted in the ring nut.
MAINTENANCE
Arrows direction on the body must
correspond to the one on the label