AML Triton Wireless Handheld Terminal - Manual (Page 67)

2 - 42
USER’S GUIDE Triton Wireless Hand-held Terminal
Host/Terminal Setup - cont’d
Section Setting Paremeter Available Options Option Description
TN5250 Settings RESET on Error 1.) Manual The user must manually reset an error
condition
2.) Automatic The Software will automatically send a
RESET to the server after displaying the error
message for the amount of time specified in
RESET Delay
RESET Delay Min: 3 seconds The amount of time to display an error
message until automatically sending a RESET
to the server
Max: 10 seconds
Long Bar codes 1.) Allow Allow long bar codes to automatically move
to the next input field
2.) Truncate Truncate long bar codes to fit in the current
input field
Web Browser Display Mode 1.) Text Use the Web Browser in text only mode
2.) Graphics Use the Web Browser in graphical mode
Custom 1 Command (Text Entry) Linux command to run when selected in the
“Connect / Reconnect” menu
Pass IP as Param Enabled/Disabled Enable/Disable passing the Host Server’s IP
address (as set up in the Host Server menu) to
the Linux command as a normal parameter
Custom 2 Command (Text Entry) Linux command to run when selected in the
“Connect / Reconnect” menu
Pass IP as Param Enabled/Disabled Enable/Disable passing the Host Server’s IP
address (as set up in the Host Server menu) to
the Linux command as a normal parameter
General Settings
Section Available Options Option Description
Auto-Connect Enabled/Disabled Automatically connect to a host on boot
Auto-Delay Min: 0 seconds Delay connection to allow network startup
Max: 60 seconds
Auto-Host (Host List) Connect to selected host on boot
Out of Range 1.) No Warning Give no warning upon moving out of range of current AP
2.) Audio Warning Sound a beep upon moving out of range of current AP
3.) Visual Warning Display a visual warning upon moving out of range of current
AP