Alinco DJ-X7 - Manual (Page 26)

26
5
Advanced
Operations
3. Press the key.
This starts the Descrambling function. The icon on the LCD
blinks during the operation. Also, the decode No. for
scrambling will appear.
4. Select a decode No. by rotating the dial.
Select a number from 0 to 16 where you can hear clear audio
output.
Pressing the [F] key allows you to descramble the
voice using the specified decode No., and change the
frequency at the same time.
To cancel the Descrambling function
Press the [F] key, then the key.
Use of the Descrambling function may be prohibited in
some jurisdictions. Check local regulations before use.
5.6 Tone Squelch Function
This function opens squelch only when a signal carrying the
CTCSS tone is received. This function allows you to monitor
specific stations without listening to unwanted signals.
1. Rotate the dial to tune to a frequency on which the
CTCSS (Tone Squelch) system is used.
2. Press the [F] key.
The icon appears on the LCD.
3. Press the key several times to display the tone
frequency with the icon ON.
4. Select a CTCSS tone by rotating the dial to match the
target signal.
Select a tone referring to "8.4 Table of Available CTCSS Tones"
on P.39.
5. Press the [F] key to conclude the setting.
To cancel the Tone Squelch function
Press the [F] key. Then, press the key several times to
display "oFF" on the LCD. Press the [F] key again to conclude
the cancel setting.
You should always set the normal squelch level
properly (see on P.15) even though the noise is cut
automatically with this function.
NOTE
TONE
SCAN
TONE
SCAN
NOTE
TONE
SCAN
Memo
TONE
SCAN