Alinco DJ-X7 - Manual (Page 21)

21
■Clearing memory channel
1. Set the Write-protect function to OFF, if necessary.
For more information, refer to "(14)Write-protect function setting"
on P.34.
2. Press the key to switch to the Memory mode.
3. Select a channel you wish to delete by rotating the
dial.
4. Press the [F] key, and press the key with the
icon ON.
A beep sounds telling that the channel and its frequency are
deleted successfully. Then, "------" is displayed on the LCD.
5. With "------" displayed on the LCD, return to the
Memory mode by rotating the dial. Otherwise,
press the key to return to the VFO mode.
When there are no more channels programmed to the
memory, press the key to return to the VFO mode.
Right after deleting a channel with "------" displayed on
the LCD, you can restore what you erased.
To undo the deletion, press the [F] key and press
the key with the icon ON.
Note that you won't be able to restore it once you
change the operating mode.
■Programmable items to memory channels
The following can be stored in each memory channel:
• Frequency
• Shift frequency
• Shift direction (+/-)
• Tone frequency
• Modulation type
• Tone Squelch setting
• Analog-inversion scrambling frequency
• Decode number for Descrambling
Introducing both free software we provide from our
website (http://www.alinco.com) and the optionally
available PC interface-cable (ERW-4C) enables you to
control and manage the configurations or previously
mentioned memory settings from your computer.
In addition, connecting the DJ-X7 to your computer
enables you to change the factory defaults and
separate each bank of the normal memory channel as
you desire. (Up to 50 banks x Desired number of
channels should equal to less than 1000 channels. For
instance, maximum 20 channels can be stored in each
of the 50 banks.)
This function enhancement is available only by the
editing software, and can't be operated with the
keypad of the receiver. Memo
MW PRI
V/P/M
Memo
MW PRI
V/P/M
MW PRI
V/P/M
MW PRI
V/P/M
MW PRI
V/P/M
4
Basic
O
perations