Alinco DJ-X7 - Manual (Page 16)

16
4
Basic
O
perations
■Mute function
This is a mute function, and it's for cutting off the audio output.
This is activated only when the [MONI] key is assigned to the
Mute function in the Set mode. For more information, refer to
"(12)Monitor/Mute function setting" on P.33.
There are also two options in the Mute function: PUSH and
HOLD. Both options put the receiver on mute, and the
icon blinks on the LCD while this function is ON.
• PUSH: You can keep the DJ-X7 on mute while holding the
[MONI] key down. When you release the key, audio output
comes back to normal.
• HOLD: You can mute the DJ-X7 when you press the [MONI]
key, and the mute state is kept on until you press the key again.
Then, audio output comes back to normal.
You can switch between PUSH and HOLD in the Set mode. For
more information, refer to "(13)Monitor-key Operation setting" on
P.33.
Only either of the Monitor function or the Mute function
can be executed at a time.
Preparations for receiving signals are now finished. Now, let's
tune to a frequency and operate the receiver.
The next section explains the DJ-X7's three operating modes.
4.4 Operating Modes
The DJ-X7 has three operating modes; VFO, Preset, and
Memory.
VFO mode...............This mode allows you to change frequency
continuously by rotating the dial.
Preset mode............The frequencies of AM, FM, and TV
channels have already been set so that you
can choose among them.
Memory mode.........You can receive signals by calling up
previously programmed frequencies.
To program to memory channels, refer to "4.6 Memory
Mode" (see on P.19-20).
■Switching among modes
Every time you press the key, you can change the
operating mode as shown below.
Preset Memory
VFO
MW PRI
V/P/M
MW PRI
V/P/M
MW PRI
V/P/M
MW PRI
V/P/M
Memo
Memo
TONE BANK
SHIFT
MW PRI
10M/1M PWR
BAND V/P/M SCAN
[MONI] key