Alinco DJ-X7 User Manual

Page 20

Basic

perations

It is not possible to program duplicated frequencies to
a skip-search channel. If you try to do so, an error
beep will sound.

■Programming to memory channel

Here are the instructions for programming a frequency to a
memory channel. It is necessary to have the

icon appear

while you are following the step 2 to 4. If the icon disappears,
press the [F] key to continue.

1. In the VFO mode, tune to the frequency you wish to

program by rotating the dial.

2. Press the [F] key.

The

icon appears on the LCD. The bank type is displayed

as well.

3. Press the

key to select a bank you wish to

program to.

Each bank corresponds to the following channel.
0-9 ...............Banks for normal memory channels.

(Note that the number of this bank may vary
depending on the factory default or can be varied
by using the editing software.)

PS ................A bank for programmed scan channels.
PAS..............A bank for skip-search channels.
Pri ................A bank for priority channels.
Select an appropriate bank as you desire.

4. Select a channel by rotating the dial.

According to the bank, the number of programmable channels
is different as follows;
0-9 ...............Note that the programmable numbers of each

channel may vary depending on how you separate
each bank. Total 1000 channels can be divided
into each bank.

PS ................0A - 49b (50 pairs)
PAS..............000 - 099 (100 channels)
Pri ................000 - 009 (10 channels)
Blinking of the channel number indicates that the channel is
free to program. When the channel number does not blink, then
this indicates the channel is already registered.

5. Press the

key to conclude the setting.

Now, the frequency you specified is programmed to the
channel. To call up the frequency, refer to "Memory mode" on
P.19.

• It is not possible to increase the number of memory

channels.

• It is not possible to overwrite to registered memory

channels with the factory default setting. If you wish
to enable memory overwriting, refer to "(14)Write-
protect function setting" on P.34.

Memo

PRI

V/P/M

BANK
BAND

NOTE