AEC Continuous Vacuum/Pressure Conveying Systems - Manual (Page 14)

Single- and Dual-Blower Continuous Vacuum/Pressure Systems Page 13
2 Safety
2-1 Work Rules
Install, operate, and maintain this equipment according to applicable work and safety
codes for your location. This includes OSHA, CE, NEC, CSA, SPI, and many other
local, national, and international regulations. Obey these specific work rules:
Read and follow the instructions in this manual before
installing, operating, or maintaining any equipment.
Additional copies are available from AEC, Inc.
Only qualified persons should work on, or with, this
equipment.
Work only with approved tools and devices.
Disconnect and lock out power while working on this
equipment.
2-2 Tools and Equipment Needed
You’ll need the following:
• Hand tools
• Fork lift or overhead lift
• Wire, conduit, and fittings for wiring runs (if receptacle is not
already in place)
• Mounting bolts with nuts and washers
2-3 Mechanical Installation
Conveying system may be mounted on a stand, or a mezzanine.
Be sure it is securely attached and additional bracing is used if
necessary. The sections on the following pages explain general
installation rules.
Read manual thoroughly before installing
conveying system.
Use approved safety straps or chains to lift the
conveying system at the marked lifting points.