beautypg.com

Extron Electronics IPL T SF Series User Manual

Page 5

background image

i

IPL T SF Series Interface • Table of Contents

Table of Contents

Chapter One • Introduction

................................................... 1-1

About this Manual

.................................................................... 1-2

IPL T SF Series Products

............................................................ 1-2

IPL T SF24 ................................................................................ 1-3
IPL T SFI244 ............................................................................. 1-3

Global Configurator

.................................................................. 1-4

System requirements ............................................................. 1-5
Installing Global Configurator .............................................. 1-5

Chapter Two • Hardware Setup

............................................ 2-1

Front Panels

................................................................................. 2-2

Rear Panels

................................................................................... 2-3

Power Connection

..................................................................... 2-4

Local Area Network (LAN) Connection

............................... 2-5

Serial Device Connection

........................................................ 2-6

9-pin D connectors ................................................................. 2-6
Captive screw connectors ...................................................... 2-7

Chapter Three • Software Setup

......................................... 3-1

Creating a Global Configurator Project File

...................... 3-2

Step one: download device drivers ...................................... 3-2
Step two: create a new project ............................................. 3-4
Step three: add a device ........................................................ 3-5
Step four: define the location of the new device ............... 3-7
Step five: save the new Global Configurator file ................ 3-8

Configuring a New Device

...................................................... 3-9

Step six: configure contacts .................................................. 3-9
Step seven: configure e-mail ............................................... 3-10
Step eight: assign device drivers ........................................ 3-11
Step nine: set the input/output configuration .................. 3-12
Step ten: set the IR configuration ....................................... 3-17
Step eleven: set scheduled actions and e-mail deliveries . 3-18
Step twelve: set monitored conditions .............................. 3-21

Building and Uploading a GC File

...................................... 3-25

Step thirteen: build the Global Configurator file .............. 3-25
Step fourteen: Upload the Global Configurator file ......... 3-26
Step fifteen: change device settings (if desired) ............... 3-27

Launching the GlobalViewer Interface

............................ 3-28

Step sixteen: launch GlobalViewer..................................... 3-29

This manual is related to the following products: