Extron Electronics IPL T SF Series - Manual (Page 45)

IPL T SF Series Interfaces • Software Setup 3-25
5 . Click Done. The dialog box closes.
Building and Uploading a GC File
Before a Global Configuration (GC) file is active in the
GlobalViewer interface, the GC file must be “built” and
“uploaded” to a GlobalViewer host device.
The “build” process compiles all of the configuration data you
have entered into the GC file for each A/V network device.
The “upload” process delivers the built (compiled) file to the
GlobalViewer host device.
After the GC file has been uploaded to a host device, you can
launch the GlobalViewer interface by entering the host device’s
IP address in the Address field of an Internet browser.
Step thirteen: build the Global Configurator file
There are two Build commands:
Build All Configurations
— compiles configuration data for all
devices in the GC file, including data for devices previously
uploaded to a GlobalViewer host device.
Build Changed Configurations — compiles configuration data
only for devices that have been added or changed since the
previous build cycle.