Wavecom W-RCI (Remote Control) V8.7.0 - Manual (Page 28)

20

Command messages XML SDK V8.7.0 Remote Control Interface
channel-config
Sets the channel(s) to be used and may assume the values “mono”, "left", "right", "leftplusright" or “iq”.
play-continuous
Indicates if the files are played in repeat mode. Select "on" to switch on the repeat mode or "off" to switch
off the repeat mode.
ip-address
The IP-address is optional and fixed to 0.0.0.0 (accept connection from all IP addresses).
port-number
Sets the TCP-port for the TCP/IP connection. The valid range is 0 to 65535.
format
Either “ip-conf” (Wavecom), “ip-pxgf” (GEW Technologies) or “vita-49” (ANSI/VITA-49).
sampling-rate
IP-CONF: The sampling rate is variable in the range 8-192 kHz for TCP/IP custom inputs, but is fixed at 48
kHz for soundcard inputs.
IP-PXGF: Parameter is automatically set using the metadata from the data stream.
VITA-49: Parameter is automatically set if the data stream contains this information. Otherwise the value
set is used.
v49-streamid
The VITA-49 stream id.
v49-event-tag-size
The VITA-49 event tag size.
v49-channel-tag-size
The VITA-49 channel tag size.
v49-item-packing-field-size
The VITA-49 item packing field size.
v49-data-item-size
The VITA-49 data item size.
v49-repeat-count
The VITA-49 repeat count.
v49-vector-size
The VITA-49 vector size.
v49-data-item-format
The VITA-49 data item format. It can be one of the following values: “sint”, “svrt1”, “svrt2”, “svrt3”,
“svrt4”, “svrt5”, “float”, “double”, “uint”, “uvrt1”, “uvrt2”, “uvrt3”, “uvrt4”, “uvrt5” or “uvrt6”.
v49-data-sample-format
The VITA-49 data sample format. It can be one of the following values: “real”, “complex-cartesian” or
“complex-polar”.
v49-sample-component-repeating
The VITA-49 sample component repeating flag (“on” or “off”).
v49-link-efficient-packing
The VITA-49 link efficient packing flag (“on” or “off”).
v49-radio-link-packets
Use VITA-49.1 packets for VITA-49 streams (“on” or “off”).
WCloudSources element