Watson-Marlow SPS - Manual (Page 47)

MasoSine SPS sinusoidal pumps User Manual 47
22.2.2 Assembling the SPS 100
During assembly, check that all O-rings are properly positioned before fitting each
component, and that all components are clean and lubricated.
SPS 100 pumps
Fitting the seal housing
l Push the reassembled seal housing into position, castellations first. Make sure
it is pressed all the way home. This can be done using the special tools as
pushers, or using a special cylindrical tool which is available from MasoSine.
Note: If a static flushing device is to be fitted, align the threaded sockets on
both sides of the seal housing vertically, so they are central to the top hole in
the bearing housing. See 23 The static flushing device.
The two versions of the SPS 100 pump
seal housing: left, where no static flush-
ing system is fitted; right, where a static
flushing system is fitted