Watson-Marlow SPS - Manual (Page 12)

MasoSine SPS sinusoidal pumps User Manual 12
7.17 Cleaning the pump
Handle substances and materials used correctly, especially when working on
lubricating systems and when cleaning with solvents. For information on cleaning
the parts in contact with the pumped fluid, see 17 Cleaning.
7.18 Faults
If an operating fault occurs, switch off the machine and secure it against unintentional
start-up.
Note: Remove the bearing housing of SPS 200, SPS 300 and SPS 400 models
only to replace or adjust the shim ring (see 21 Adjusting the shaft). Do not
attempt to dismantle the power end of the pump or replace the bearings.
Pumps needing repair, servicing, new bearings or other work on the power
end must be returned to MasoSine for attention. Special training is available
for users of SPS 200, SPS 300 and SPS 400 models. Please contact MasoSine
for further information.