Watson-Marlow 505Du - Manual (Page 22)

22
indicate if the pump is running or stopped and the motor direction. Its use could
be to signal to start the next sequence of say a filling machine such as controlling
selector gates on the exit side.
Line 1 will change state as soon as the motor starts or stops. The signal can be
selected to be either high or low to show running.
# 1 - R U N H I G H L O W
Enter, or Step, Enter
Line 2 will change state as soon as the pump direction is changed. The
selection is made relative to the output shaft rotating clockwise. You can select if
this direction is too high or low.
# 2 - C W H I G H L O W
Enter, or Step, Enter
After the selection has been made the screen will confirm.
S T R O B E - 1 R U N = H I
S T R O B E - 2 C W = L O W
Confirmation messages
S T R O B E D E F A U L T
>
The SETUP menu returns
11 10
20 18
Line 2
CW/CCW
Line 1
Run/stop
By following the prompts, all settings can be restored to the factory defaults.
Default